Louisiana Reloader
Well-Known Member
10-4, I see. Thank you very much sir.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
6.5 PRC Sherman Improved
- Thread starter bsnyder
- Start date
Help Support Long Range Hunting Forum
That's not the only new .257 reamer Mr Rich has coming.!
All my gun parts are at the smith waiting too…Me and Lieutenant Kenyon are going to be doing some comparing soon
All my gun parts are at the smith waiting too…Me and Lieutenant Kenyon are going to be doing some comparing soon
lancetkenyon
Well-Known Member
There are very few out there. So few, in fact, Rich had to get the reamer made for me. He didn't have any in stock. I think just two or three, after I did all the testing of the 6.5PRC/SI last year.
Once mine is built, I will post up testing results. I am expecting a 133 @ 3150-3200+ from my 22" barrel.
Louisiana Reloader
Well-Known Member
Nice! Looking forward to hearing those performance and data numbers. Those expected velocity numbers are great--especially for a 22" barrel. Thanks for sharing.
Following
Howd the 6mm work out? I know a few guys running standard 6prc and I shoot a 6saum.
H
Hope to have a report within a week.
bowhunter1287
Well-Known Member
- Joined
- Feb 3, 2015
- Messages
- 371
Has anyone tried like 110 or 118 hammer bullets in the prc/si to see what kind of velocities you can push it to?
Justice1327
Well-Known Member
How did it perform?
It worked well and good accuracy with 109 hybrids. I just couldn't get it as accurate as I wanted. Below results were from new Lapua brass on about a 45-50 deg. day. It has pretty impressive ballistics to 1000yds. I think it would be ideal for many as a hunting cartridge, but it is a bit much for competition.
Attachments
Last edited:
Justice1327
Well-Known Member
Thanks…anything special about the reamer? Or just a neck down ? Freebore.
I ask because my freebore is for 87-90g
As far as I know, I think the reamer Travis @ TS Customs used is a .105" freebore. As for loading, just a simple neck down - I used a .269" bushing on Lapua brass. I think @Huntnful uses a .270"? For a wildcat, this one is about as simple as it gets. Check out this link to Huntnful's journey with it - he gives far more detail and some kills with it.
www.longrangehunting.com
6 PRC
Have spent just a little time behind this cartridge now. Rifle was built by TS Custom. KS1 Adjustable Stock Bartlein 7.5 twist 24” Rem Varmint Lone peak Fuzion Alpine cut M5 with hinged floor plate March FX 4.5-28X52 I’ve only tested H4831SC so far because I like how consistent and clean...
