• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Semi-tight bolt close on handloads

So I'm pretty perplexed with this one… I have a 243 Win that I built out of spare savage parts. I had four boxes of different factory loads (Winchester, Hornady, and Herters) that I shot out of it. All of them grouped very well, and all of them fit nicely into chamber without any resistance on closing the bolt (remember this part for later. So, I took some of the Winchester once fired cases, prepped and seated some 87gr VLD Hunting pills I had laying around.

Now these cases were FL resized, trimmed to spec according to Hornady's manual, and measured with calipers and an LE Wilson case gauge. I used a Hornady OAL gauge, and seated the bullets .020" off based off of the ogive.

The new rounds chamber, but there is a slight resistance when closing the bolt. It still closes, but certainly takes a bit more force than the factory loads.

I have since measured the seating depth vs the factory ammo, and the VLD's are seated just a little deeper vs the factory ammo.

View attachment 410398View attachment 410399
I also measured the once fired cases vs a prepped and primed case, and the prepped cases are just shy of the fired ones.View attachment 410400View attachment 410401

I'm just curious what I did wrong. Am I ok to shoot these with the semi tight bolt?
Screaming shoulder bump!!
 
Top