-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
RAMSHOT LRT POWDER
- Thread starter elkaholic
- Start date
Help Support Long Range Hunting Forum
nealm66
Well-Known Member
Nice! Man that's a lot of powder. Probably a good combination considering LRT is pretty reasonable. If memory serves, it was an except able temp powder. Somewhere I found it's expected rate, might have been on westerns site. Might be worth a try to see if it reflects the same in your cartridge
Bghunter338
Well-Known Member
I just read this whole tread, and now I want to try some in my 7 STW with 175gr or 180gr. Does anyone know where I can find a safe starting load? Thank you.
Bghunter338
Well-Known Member
Should I just back down a couple grains to start?
Propellant Profiles | Handloader Magazine
Check that out.
I think the STW has a higher case capacity then the 28 Nosler. I'd probably start close to max.
NVM, don't do that.
From everything I've read and reviewed, they're super close in capacity. Owned both over the years. Different brands of brass would likely make the biggest difference in actual case volume.
Bghunter338
Well-Known Member
Yeah there mostly Remington case's
Rhett Crider
Well-Known Member
QuickLoad's shows same H2O capacity. 97g
See the post on this page w burn rates.
www.longrangehunting.com
RAMSHOT LRT POWDER
I've only been reloading for just over a year.last year i was having problems shooting barns lrx 168 gr . I dropped down to 150 gr was able to get them to shoot. This year I put a limb saver to the barrel and bought a new break . Could not get any H1000 so switched to LRT now I'm able to get...
"Finally got an 80F day on the range today, and 89gn of LRT, CCI-250, Peterson 28Nosler, 195 EOL, is pretty sticky on the bolt lift
I was going to use the high velocity node in my 27" barrel, but I think may have time to re-test, and back it back down to the 87-87.4 node?!
Previous testing in 43-50F weather, ES/SD were good & stable. It didn't go RL26 atomic device, but for sure at MAX, at 80F." Some of my recent results.
I was going to use the high velocity node in my 27" barrel, but I think may have time to re-test, and back it back down to the 87-87.4 node?!
Previous testing in 43-50F weather, ES/SD were good & stable. It didn't go RL26 atomic device, but for sure at MAX, at 80F." Some of my recent results.
