Scythe issues?

[Tgunz64]

Hey guys. Over on Rokslide there is a thread going where people are talking about some issues with the Scythe. Mainly weld fails. Anyone here have that issue or some other failure? Little nervous now that I ordered one. Some failures with 22" 300 PRC or 20" 280ai. As a couple examples. I'm going to be using mine with a 24" 300prc and a couple smaller calibers. 17.5" will be the shortest in 7mm08. And an 18" 6.5CM.

 

[EFouraker]

I blew mine up in less then 200 rds. Silencerco fixed it and had it back to me in about a week.

I also had a hybrid46 blow up a couple years back. It was also replaced under warranty. The same can now has a rattling baffle stack and needs to go back for warranty work again.

I'd recommend buying a thunderbeast Magnus

 

[Gabe22BR]

I'm sure there is a min barrel restriction on it, for the pressure generated.. I'm sure a quick call you'll get it straightened out..

 

[waspocrew]

I'm sure there is a min barrel restriction on it, for the pressure generated.. I'm sure a quick call you'll get it straightened out..

That's the problem - it's advertised as "no barrel length restrictions". Clearly there's an issue. I just got one last week - it's going to stay on my 6 ARC, 6 Creed, etc.

 

[Gabe22BR]

Other than getting it extremely hot( which all TI cans have warnings on) , must have been made on Fri..
I'm sure they'll fix it.

I seen one, while I was on the hunt for another brand. I had to pass on it, it wasn't exactly what I was wanting.