Scope Mounting

[Dragoon300]

So……how does that affect your scope/eye relationship when bringing the rifle to your shoulder?

I always adjust my eye relief as to get full view in the scope at highest scope power setting when the rifle in position ……without moving my head to achieve full view in the scope. To get my proper clearance …..I close my eyes, shoulder the rifle, then open my eyes. If I do not have a full field of view….I repeat this process until I do. When finalizing the adjustment…..the final movements are less than 1/4". memtb

As I originally stated "when possible" although on a pic-rail it isn't that hard to do. Also hold the scope and mount forward in the rail slots so they too are supported against recoil.

 

[JAYgs8163]

All my scope mounting set-ups(whether 338ML or 6.5x47L) are mounted in a similar same fashion:..regardless of the brand of scope/ring/base…. I prefer as much surface area(rings to scope body as the mounting dimensions will accommodate(especially with heavy recoil/use rifles) , a pic-rail base/rings(best quality components/scope I can afford), and a torque wrench! Heavy calibers often need up-sized base mount screws fitted..or get pinned.
-All components assembled are checked for alignment and mated surfaces using a basic scope alignment/lapping tool( the lapping tool can be used to "check" scope/ring contact area of +75%. Don't take anything for granted! Everything must be perfectly mated/aligned…
-Scope base is bedded/stress free(or pinned) if there us any clearance/off-set with Devcon(24 hour). Torque to maximum spec. My preference is to not use Loctite on the mounting screws…If properly cleaned mated/torqued, "lightly" lubricated screw will secure equally/better under spec'd torque. IME, ANY foreign material(rosin, Loctite, etc,) can invite clearance issuers under recoil stresses. Metal to metal……
- If bottom ring contact area(using the scope mount bar) is less then 75% they are lapped. Don't take this aspect for granted…check.
-Torque scope rings to maximum allowable spec from scope/ring manufacturer….Same with the rings to scope base. Do not exceed!

6,5x284 with epoxied base, and 300WM with pinned base. Both, ARC M10 rings…scope/ring max torque spec is 25"/pds.
View attachment 640592View attachment 640594

Isn't the torque value for ARC rings 55 inch lbs?

 

[FullCurl8]

First thing I would do is contact Hawkins and see what they say. They make great products and if there is an issue they will get it taken care of. Another thing I always do when mounting scopes is to clean both surfaces with 99% Alcohol where the rings and tube mate.

Best advice of the thread.
When we have scopes moving in a rifle, and it's really really rare, we find the problem. I don't like bandaids.
Never loc-tited ring caps in any Ultra Mags/Lapua Mags. But I have seen a ring set or two out of spec.
Sometimes mechanically zeroing your scope and using a grid pattern bore sighter will show out of spec rings. Not necessarily the reason it's slipping of course, but a ring that's off axis is not helping for sure.

 

[hemiford]

With conventional rings I've put a piece of cellophane tape on both ring halves. I did this to avoid
marring the scope, but I figured I was also getting a bit of a "rubbery gaskety" gripping effect too.

 

[Recon$$]

Is there a specific type of rosin to get.

I bought the following:

https://www.amazon.com/gp/aw/d/B07DHBNK4V?tag=lrhmag19-20

Bottle will last you a lifetime. Of course it's not available right now.