TXAoudadKlr
Well-Known Member
Anyone using the 260-285gr in 338 Norma
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Official Hammer bullets Terminal Performance (picture heavy)
- Thread starter TXAoudadKlr
- Start date
Help Support Long Range Hunting Forum
dennisinaz
Well-Known Member
I've used them in 340 Wby, similar velocity. I will try them on my 338 Norma this winter
Nevrsummr
Well-Known Member
codyadams
Well-Known Member
What was impact velocity, bullet, and twist rate? Looks like the petals didn't come off on that one, along with the tumbling. Still killed well, which is the most important part!
cabelasken
Well-Known Member
I just took two kills with the Absolute 130 Gr out of a 280 Ackley. one was a facing 60 yd mulie 3x3 and the other was a cow elk at 365 yds. on the mulie, the shank was recovered under the skin just in front of the opposite side ham. No petals were recovered. As expected the entrance was an explosion -grapefruit size debris on the shoulder blade and both rib cages were destroyed. Believe it or not, the buck still ran nearly 100 yds before piling up. As launch velocity was 3285, this amount of damage should be expected. The cow was struck just below the heart and took out the far side front leg. the cow rolled down the hill and was perched on a hill. a 175 shot to the back of the head ended that. Although max velocity out of my rifle is over 3400 fps with this bullet, i found 3285 to be the ticket for accuracy. 1/2 moa from a factory X-bolt. My backup x=bolt was borrowed by another member of our party when it was discovered his scope was mounted incorrectly. He took a cow at over 350 yds with a 140 Absolute out of t hat 280 Ackley at a muzzle velocity of 3200 fps and had no issues. These are the first 3 kills i've witnessed with Hammer bullets and they performed as advertised. I believe there are other bullets that will also do the job, but which of those can be loaded to the velocities of the Absolute Hammers? I'm getting 150 to 200 fps more out of similar wt bullets and that translates to flatter trajectories and better terminal performance.
Nevrsummr
Well-Known Member
App puts it at 1951fps 1:8 twist. The petals did come off. I found one of them. May have been a little bit faster as entrance was a few inches higher than where i was aiming. Could have dialed 1/2 moa less and been right on. That being said i really appreciate the bullets performance entering higher than i wanted but still taking her vitals out quick.
DocTorT
Active Member
Skimmed but didn't find- Any take a bull elk with the 124 HH out of a 6.5 CM? Anything over 400 yards?
Love the 6.5 caliber and hesitant to buy another rifle while starting a new business, but everyone here knows what that fever feels like!
Love the 6.5 caliber and hesitant to buy another rifle while starting a new business, but everyone here knows what that fever feels like!
Velocity?
This is virtually the same projectile terminal performance wise...
CO elk hammered 6.5 Creedmoor
So second season elk. I made this load for a friend and he shot this bull elk at 608 yards with a 123gr absolute out of his Pierce engineering 6.5 creedmore. Bullet leave right around 3160fps. Bull stood still for a few seconds after hit and fell right over. Everything inside was mush and hole...
codyadams
Well-Known Member
Ok, looks like some of it is still on, not flat fronted like they are meant to, unless that is a separate petal laying with it. What bullet is it? Thanks!
aalyea
Active Member
Same round I used on my bull this year at 345 yds. Exited. What's your recipe?
Nevrsummr
Well-Known Member
Cleaned it up and looked closer today. Looks like only 1 pedal shed. The one i found. Other 2 peeled back as you see in your blown up pic. Its the 155. Out of a 28SM with a mv of 3430
