About 200-300So my question would be how many rounds between cleanings are you firing at Barbourcreek? Really enjoying the videos you put out!
Creedmoor hot barrels we don't let the coo between 40 round increments in class
About 200-300So my question would be how many rounds between cleanings are you firing at Barbourcreek? Really enjoying the videos you put out!
Yes out of 5 schools 2 barely show at 100 yards the other 3 are between 1 to 2 inchesThanks for posting, extremely interesting! I would think at 100 yards it would be pretty close, clean or fouled? At what range do you think this really starts showing?
I respect Brian immensely however, there are new products out that do work. Have been using this one for a couple of years. Speedy showed this to me when I was picking up a rifle he built for me. Yes, it does work as the bore scope does not lie.I was with a small group talking to Bryan Litz at SHOT one year. He said they the rely on the doppler radar to tell them when to clean. Shooting many barrels etc. He said that at 100 rounds you could see a change on the Radar. He also said that you could NOT clean it adequately with chemicals alone.
Just repeating what he told us.
I respect Brian immensely however, there are new products out that do work. Have been using this one for a couple of years. Speedy showed this to me when I was picking up a rifle he built for me. Yes, it does work as the bore scope does not lie.
Believe me it took several times to convince me using my own bore scope that this really does work cleaning without using the brush save the chamber ring (it does get most of it without the brush) as he shows.
Spent too many hours to count with Speedy in his shop, shooting and cleaning rifles. He is just about the most demanding person about cleaning down to the bare metal I have been around.
One more comment about shooting clean bore first shot. For hunting, with my rifles that Speedy built with Kreiger tubes the POI is not really much different that after a fouling shot so I just run a patch or two to get the oil out of the bore and shoot. Now with a factory production barrel this is not a good Idea as those are a completely different story.
Yes--my bad for not mentioning this. I do use a nylon brush to apply cleaner to the bore. Just dribble some on the brush while turning it in my bore guide opening then down and back dribble on a little more and down and back. I have used the patches as well, but this works better for me. I do use only patches to apply the accelerator though. A short blast of CRC brake cleaner to clean the brush and it goes in rod holder. If I apply another round of the chemical, I only use the patches for both and the Dewey with the brush stays in the holder.At the 3:00 minute mark he is using a brush?