Load data for 6.5 prc

Anyone have some good loads in a 6.5 prc.
I'm planning on using n565
147gr ELD-M 3,000 fps using 59.5gr N565 Tikka T3X 24" barrel
We always FL resize our brass this seems a necessity with this calibre mostly Norma brass and Hornady. Frankly we think it's an overrated cartridge a 270 gives the same performance
This N565 works the best we found
 
What brand brass are you using. If I get much over 55.5 grs. RL26 with ADG brass I get pressure signs. I run 55.0 grs. At 2880 fps. Have lots of N565 and N570. Just loaded some 300 wm with some N565 loads. Just opened an 8 pounder of RL26. Last I have. It has my best loads in 300 wm, 6.5 PRC and 257 bee. Looking for an alternative.
I have been using ADG brass and Hornady factory brass. Ran it up to about 58.5 before pressure but did not see good results at the higher charges and 57 looked great. My preferred brass is ADG but tried both and didn't see a big difference.
 
7828ssc is a good choice (if you have or can find any)? 560 and 565 are 2 of the best for this cartridge and 7saum. the 150/160/165 series are another choice, but will have 75-100fps less velocity and are cooler burning.
 
Top