• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Help -- about to purchase my first set of reloading equipment!

You'll need a full length sizing die and a seating due. The sizing die contains the recapping pin. You might eventually choose to neck size only, but most will suggest starting with full length sizing.
 
You'll need a full length sizing die and a seating due. The sizing die contains the recapping pin. You might eventually choose to neck size only, but most will suggest starting with full length sizing.
He can Neck size only too with a FL die. Just back it out until it just bumps the shoulder. Theosmithjr
 
Hello all,

I have decided to take the reloading route. I have never done it and have no equipment. As of now, I am only planning to reload for my 7mm rem mag.

I am looking at purchasing the RCBS Rock Chucker Supreme reloading kit. I know that I need calipers and dies. Any die recommendations? Also, are the 2 dies in many of the sets all you need? Also, is an electronic powder scale a good idea over the manual scale? As in how hard is it to get accurate with the ".1, .2," etc. measurements?

Thank in advance. Excited to get into this.
I started reloading in 1971 and currently reload for about 13 rifles and pistols . I started out with a Rock Chucker and eventually moved up to a Dillon 550 . I think a Rock Chucker is a great press for a beginner. I think that you'd be well served by getting a digital scale . I used a manual scale for years and was amazed at how much time I saved by not using a balance beam scale .You'll probably end up upgrading your gear as you get more proficient but that's part of the learning process. Good luck and have fun .
 
Warning! This thread is more than 6 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top