HELP! 25 SAUM Seater Die

[ArmaHeavy]

Hey Everyone,

I'm building a 25 SAUM and I can't find a seating die. I'd prefer to use an arbor die, but will use an in-line if forced to.

My original plan was to buy a 6.5 SAUM LE Wilson micrometer seating die and drop a 25 cal seating stem into it, but Wilson said that their 25 stem won't fit in their 65. SAUM die. I was a bit shocked by this.

Anyway, please let me know if you can think of a way to accomplish this.

Thanks!
AH

 

[Shooter264]

25 is only .007" smaller. 6.5 seating stem should work fine, may need to drill the stem ever so slightly if it is contacting the meplat if wanting to use arbor die.

I used Redding 7 saum competition seater and have swapped the stem out for the 25 cal stem

 

[Philj]

Get a SAC Infinity die last seating die you will ever need.

 

[Get_Saum]

Similar to Shooter264, for my 6 saum I've used my Redding 6.5 saum competition seater. I didn't need do anything to the seater stem but was prepared to drill it out if necessary.

 

[Hydra6]

I load 25x47 for PRS - I just use the 65x47 seating die in 65x47 configuration to load 25x47.

I am building a 25 SAUM also and plan on using a 65 SAUM die "as is"

 

[Phil Rizzo]

Get a SAC Infinity die last seating die you will ever need.

Just got one in, with 4 stems.
The mitutoyo mic top gives me confidence

 

[Jakeweb09]

Plan on ordering a SAC DIE at some point, but currently been running a 7 Saum Wilson micrometer seater for an arbor press..been getting really consistent seating even with 7mm stem

 

[ArmaHeavy]

Plan on ordering a SAC DIE at some point, but currently been running a 7 Saum Wilson micrometer seater for an arbor press..been getting really consistent seating even with 7mm stem

And you're using the 7mm stem to seat 6.5 or 25?

Thanks!!

 

[Jakeweb09]

And you're using the 7mm stem to seat 6.5 or 25?

Thanks!!

Yes