Hammer Hunter Load Data, (See page 1, Post 8)
- Thread starter GLTaylor
- Start date
Help Support Long Range Hunting Forum
I refuse to YieldYou are just jealous, it is the do all rifle
adk hunter
Well-Known Member
GLtaylor
6.5 Creedmoor
110HH
Tikka x3 in Alterra stock
Sig Sauer brass (new) sized
CCI regular #200 primer
COAL 2.74
.28 MOA
no velocity data
6.5 Creedmoor
110HH
Tikka x3 in Alterra stock
Sig Sauer brass (new) sized
CCI regular #200 primer
COAL 2.74
.28 MOA
no velocity data
Anyone loading Hammers for the 6.5PRC that's been looking for a LEE crimp die, they're back in stock at Lee.
https://leeprecision.com/product.php?productid=6281
https://leeprecision.com/product.php?productid=6281
Kmccord
Well-Known Member
I have a 6.5 Grendel AR-15 and was looking into buying dies and start reloading for this cartridge. Anyone have any experience loading Hammer Bullets for this cartridge? I looked at the load data and did not see any loads, so thought I would reach out and see if anyone has done some loads for this cartridge. This will be used as my Hog rifle and was thinking of the 88gr or 99gr HH to start off or maybe something in the absolute.
Rick Richard
Well-Known Member
Any 300 Norma Mag Improved load data out there with Hammer Hunters?
epags
Well-Known Member
To digress slightly...zoowie. (See earlier posts on this thread) Got my Nosler #9 manual. Way better than Sierra or Horndy manuals.
What a difference (caliber wise) that the old Nosler #1 (1976). Only short comming is that it doesn't address cast bullets.
What a difference (caliber wise) that the old Nosler #1 (1976). Only short comming is that it doesn't address cast bullets.
I think I'm going to load up some of these 85 Grain, 6.5 HH's and feed them into my PRC. Curiosity is driving me crazy. Any powder suggestions.
I've tried that stuff. Can be pretty messy to load with. Pain in the Buttocks if you have to unload due to pressure but I'll give it a go. Stuff gets all over when unloading hot loads.
True but it sure does measure smoothly. Loads are super dense too. I'm working with Staball and IMR 4451 in my 280 ai right now.I'm in the mid 3200s with Staball and 3300s with 4451. Have'nt shot em for accuracy yet, just pressure.
Haven't tried it in the PRC, but in my 25-06 RL23 works pretty good with the 92 HH. Might try that, if you have any.
Lrreloader
Well-Known Member
What is everyone's go to .308 hh grain bullet for a non target woods gun?
Go back to post #8 and look at the spreadsheet. If nothing, go to the Absolute Hammer Load Data thread and spreadsheet.
G
G
