dukslayer4051
Member
They loads cycle fine even after charged. It's only once the round is fired
7 prc
- Thread starter dukslayer4051
- Start date
Help Support Long Range Hunting Forum
Yes but if you are not bumping the shoulder much you can screw the die in more and it might help. It's also good to know how much you are sizing for case life, consistency. I have also seen dies that were bumping shoulders way too much when set up per the instructions. It's a cheap tool. I had a lee die that was sizing .015. Way too much and lead to a case head separation.
19elkhunter51
Well-Known Member
Okay. I am old and not familiar with "clickers". Can someone please educate me?
Only prevalent in the PRC cartridges .Something about the original Saami drawings.
I rented the reamers and did all my guns in about 1 hour with the tool provided by the renter.
I did my 6.5 ,7 and 300 prc rifles.End of problem go enjoy life.
Really fellas it is the easy button.
For more info look up Alex Wheeler gunsmith.He came up with fix and gave it to the shooting community.
Just a finish reamer and extension with some cutting oil,,all provided by renter.
Before this my 7 Prc was the most frustrating dam gun.I tried all the different brass and a couple of those stupid expensive sizers,,,Fail
Ream it once and never even think about it now
I rented the reamers and did all my guns in about 1 hour with the tool provided by the renter.
I did my 6.5 ,7 and 300 prc rifles.End of problem go enjoy life.
Really fellas it is the easy button.
For more info look up Alex Wheeler gunsmith.He came up with fix and gave it to the shooting community.
Just a finish reamer and extension with some cutting oil,,all provided by renter.
Before this my 7 Prc was the most frustrating dam gun.I tried all the different brass and a couple of those stupid expensive sizers,,,Fail
Ream it once and never even think about it now
