6mm Creedmoor - Hammer Bullets

[hickswr]

I have a 24" 1:7.5" 6 Creedmoor. I actually got quite a bit better groups with the 101 vs the 88gr HHs.
H4350 @ 3220fps, into tiny little groups out to 400+. The 88s were above 3300, but at every charge weight, the 101s were more accurate in mine. Although, nothing over .65" 3-shots at 100 during testing.

What temp and elevation were you shooting them at 400+?

 

[Unoboats]

7.5 twist works fine with the 101's. 42.5 gr of H4350.

 

[blueprairiedog]

Seating doesn't matter in mine -m24 8 twist bartlein-6.5 staball is one hole at 200 but h 4350 always shows the best numbers mine doesn't seem matter what you put in it.I need another one in a light ground hog rig.Good luck

 

[RogerPA]

Hello: I have a new build, 6mm CM w/Bartlein 23" Barrel. I want to use Hunter Hammers 88gr. and 101 gr. Just not finding much published load data. Just a couple loads on the spread sheet w/ H4350. Has anyone tried any loads with Stabil or RL 16 that they could share their results? Much appreciated.

Out of my 1-71/2 twist, I chose the 87 grain Absolute Hammer for my 6 Creed. Settled on 47.0 grains of StaBall6.5, Federal 210M primer, Nosler brass, COAL of 2.735 @ 3332 FPS from a 22" AlTerra Carbon barrel. Verified under 1 MOA to 600 yards, as long as the wind isn't wicked. Quite honestly, over 400 yards the 103's I've toyed with shoot a bit better out of this gun. But for hunting, it's the 87 grain AH all the way! Initial terminal results have been impressive!
Good Luck with yours!

 

[PapaSmurff]

I've got a Bergara HMR Pro with 26" barrel 1 in 7.5t 6mm Creed that's shooting bughole groups with the 88gr Hammer Hunters but would like to try the 101's. My load is 43.0 H4350 CBTO length of 2.222" with velocity of 3,360 FPS.

 

[lancetkenyon]

What temp and elevation were you shooting them at 400+?

About 1500'AMSL and 60*F when I shot them at a target.