25 Creedmoor question

[6.5saum/300rum]

Sweet looking rig. I have a 25creed and 25PRC with unknown reamer, I'll have to ask my GSmith.My good friend has both cartridges and uses the BJ reamer for both. Both his guns shoot same bullet same powder charge substantially faster than mine. Mine pressures out much sooner unfortunately. I have 57.5g N565 getting the 134 to 3020-3040. Cci200. Also , H1000 at 57 had pressure with Magnum primer @ 3070

The first 300rds down the barrel were with Berger 135 58g H1000 virgin Hornady brass. Zero signs of pressure.

This must be the 25prc info?

 

[Bud LaRoche]

This must be the 25prc info?

Yup

 

[6.5saum/300rum]

Yup

I could tell by the powder charge, you might have the op confused with your velocity. I think he was looking for real world numbers with the creedmoor case. What speed are you getting in your 22" creed barrel?

 

[JAYgs8163]

Yes. I'm looking for 25 Creed info!! Not PRC.

 

[Bud LaRoche]

22inch Bartlein 1;7 25creed 2845fps 134eldm H4350

 

[Bullbuck]

I went with the Blackjack,works great with the 133 berger.

 

[Dmagna]

Reading is fundamental

 

[JAYgs8163]

I went with the Blackjack,works great with the 133 berger.

What brass are you all running? I see ALPHA makes brass and also has their own reamer design. Does it make more sense to run the Alpha reamer over the Blackjack 2? Seems to me it would!!??

 

[Dmagna]

I am running alpha. It's okay, wish it would anneal prettier. I will mess with lapua soon.

 

[JAYgs8163]

I am running alpha. It's okay, wish it would anneal prettier. I will mess with lapua soon.

What reamer did you build your rifle with?

 

[Dmagna]

What reamer did you build your rifle with?

I am unsure

 

[Bullbuck]

I run Alpha 25 creedmoor brass. It works fine with the Blackjack reamer. I did turn necks,not sure I needed to.

 

[JAYgs8163]

I run Alpha 25 creedmoor brass. It works fine with the Blackjack reamer. I did turn necks,not sure I needed to.

That's what I'm trying to avoid is "turning necks".

 

[CaptDru]

My 25 CM was chambered with the Blackjack reamer. Not sure what version though. Had it chambered by Southern Precision and I don't have to turn necks with Peterson Brass.