That is impressive when you think I am besting that by just over 100 fps and using almost 60gr. of IMR4831 in a 7 SAUM. That 7mm-08 is running pretty efficiently. That's what I am looking for.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
7mm-08 AI on Small Primer Brass
- Thread starter Weaver93
- Start date
Help Support Long Range Hunting Forum
Justice1327
Well-Known Member
My favorite cartridge…I have 6, but sold that many too.
I ran across it once myself, but can't find the link anymore. I would love to find it.
Last edited:
Justice1327
Well-Known Member
Many shooters like .243 SRP brass too…can't find any :-(
std7mag
Well-Known Member
With my Stevens 200 that I bought used, I ran it as standard 7mm-08 for a few years.
Then reamed the chamber to 7mm-08AI.
Finally pulled the barrel off after 6.000 rounds that I put through it.
Except for Lapua, I've pretty much run every brand.
Never worried about SRP.
PPU (PVRI Partizan) was the best brass I used.
I use it for every cartridge that I can now.
Then reamed the chamber to 7mm-08AI.
Finally pulled the barrel off after 6.000 rounds that I put through it.
Except for Lapua, I've pretty much run every brand.
Never worried about SRP.
PPU (PVRI Partizan) was the best brass I used.
I use it for every cartridge that I can now.
Try American Reloader. They some times get a lot of pulled brass.
Here's one; https://www.rmrbullets.com/product-category/cases/?wpf_filter_cat_1=232
Wilderness Blacktail
Well-Known Member
Regarding masking symptoms can you elaborate on this?
Are you folks seeing increased velocity with lift, extraction, primers and case heads etc looking normal??
OR
Are you seeing ejector marks and or knowing u are having pressure but pockets stay tight for longer?
