The best die lock rings that will never ever come loose?

[VinceMule]

I replaced all of mine (Redding, Forster, RCBS, Lee, Lyman, Hornady, Whidden, Newlon, etc.) with these.

So did I! Like them so well I had a 3 dozen satin Ni plated on a job.

 

[300WSMGUY]

Hornady make a good lock ring. It will stay put if secured properly.

Sure-Loc Die Lock Ring (Single)

Sure-Loc Die Lock Ring (Single) by HORNADY Product Overview: The Hornady Sure-Loc Lock Rings let you make precise adjustments on all standard 7/8"-14 dies and accessories. They feature wrech flats to allow for easy removal and installation of your dies into your press. The split ring...

www.midsouthshooterssupply.com

I use the Hornady lock rings on all my RCBS , Lee and Redding dies. They stay put and are easy to adjust.

 

[Lee Deming]

All of my die sets were Lyman until I bottomed one out with the wrong shell holder. Couldn't get another Lyman at the time for my .375. Went with RCBS and could not get it to tighten without a lead shot under the brass set screw on the third try. Very frustrating. I didn't know that this was a problem because I had never encountered it with the Lyman sets.

 

[KsKevin]

I use the hornady rings (all my dies are Redding and I hate the set screw lock rings that come with their die)

 

[Beluebow]

Another vote for the Hornady.

 

[chav0_12]

I buy Hornady lock rings when I buy any new set of dies. They flat work.

 

[Ol' Red]

One more vote for Hornady lock rings here. They just work.

 

[Bullbuck]

Hornady

 

[Hard rock]

Hornady

Looks like Hornady won the hunt

 

[Taylorbok]

If you need one more I also run Hornady. It's a bonus that they are actually reasonably priced.

 

[SAM55]

Yep - Hornady for me. Good quality, cheap and two flats on them for a wrench!

 

[Salmonhead]

I want to buy some lock rings that will actually stay put so that when I pull out a seldom used die I can trust that it is 100% exactly where I left it. What's the best out there?

Forster

 

[5280Reloader]

Hornady rings are the best. They will not damage the threads of your dies.

 

[RWE]

+ "however many" on the Hornady. New dies get these before use regardless of what is on them.

Hard to get too excited about die rings but when someone asks, these just work, 110%. IMO, the wrench flats on the Hornady rings knock other/similar rings without, out of contention. I am more than happy with these that I won't change to another.