If the case you have on hand is sizing to hard id run it through it and try it. No forming needed. Itll most likely push shoulder back out a couple thou
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Shoulder bump problem or no problem?
- Thread starter Tidesloe
- Start date
Help Support Long Range Hunting Forum
Shane Lindsey
Well-Known Member
- Joined
- Jul 13, 2010
- Messages
- 3,934
So do you use the 30 Nosler die to size the body and then bump the shoulder with the Sherman die? Or other way around, bump shoulder and then size the body with the Nosler die?
Tidesloe
Well-Known Member
I haven't tried 2 die sizing yet, but I will this weekend. I'm gonna get plenty of pieces to work with, instead just a few.
Run in nosler then sherman
Tidesloe
Well-Known Member
If anyone is still hanging around this thread, I have an update. We're finally getting somewhere on it. The reamer that cut my chamber is out of spec, pretty bad. Supposedly it's on its way back to Rich and then back to the reamer manufacturer. I'll loose a little barrel length to clean it up, but with a good reamer it'll be fixable
Am glad there's an answer and a solution to the problem. Would have been much worse for you had it remained a mystery.
Cheers,
Chris
