Should I be worried about my neck clearance?

Right here^^^^. They should be able to supply the reamer specs, if they will not, secret sauce crap, good company to avoid.
I have said this for yrs, anyone who gets a custom chamber done, should ask for the reamer print of the reamer used. It at times can answer questions that may have one perplexed.
I only have two custom chambers and I ordered the reamer for both of them the one rifle I'm on my third barrel is being done right but with the same reamer that has only been used three times I'm guaranteed everything will fit and the reamer is Sharp
 
This is an awful lot of posting for a simple problem. Like I said before, fired Norma Brass measures .314. Loaded Peterson brass measures .314. Plain and simple, that is NOT enough neck clearance. Go back to Norma brass or turn the Peterson brass. This is not rocket science.
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top