backwoods83
Well-Known Member
- Joined
- Jan 8, 2011
- Messages
- 3,485
Lost interest in this project, gonna take a loss.
BCA right side charging upper receiver.
BCA 15" Mlok handguard
BCA bolt carrier
Monster mk .136 bolt (Grendel II)
Mcgowen custom 7.62x39 with a true .300/.308 bore and groove in 12 twist chambered to headspace with a Grendel type II bolt, and to shoot 110gr Noslers, 125gr TNTs, and 125gr Cavity Back MKZs. Midlength gas with .100" port/.750" journal for a Superlative Arms adjustable gas block, to run full house loads without being over gassed or to run suppressed. CMMG midlength gas tube.
BCA flash hider just there protecting the 5/8-24 muzzle threads.
This has never been fired, but should be very accurate. Receiver face was squared and the barrel bedded with blue loktite, barrel nut torqued at 40lbs.
200 Lapua cases.
300 Starline cases.
150 PPU cases.
4 pounds of CFE BLK
All that is needed to finish this, is the Superlative adjustable gas block, it needs the clamp on version, because Mcgowen did not dimple the barrel. I have 990$ invested in this project.
Looking for 800$ shipped, obro.
More pictures by request.
BCA right side charging upper receiver.
BCA 15" Mlok handguard
BCA bolt carrier
Monster mk .136 bolt (Grendel II)
Mcgowen custom 7.62x39 with a true .300/.308 bore and groove in 12 twist chambered to headspace with a Grendel type II bolt, and to shoot 110gr Noslers, 125gr TNTs, and 125gr Cavity Back MKZs. Midlength gas with .100" port/.750" journal for a Superlative Arms adjustable gas block, to run full house loads without being over gassed or to run suppressed. CMMG midlength gas tube.
BCA flash hider just there protecting the 5/8-24 muzzle threads.
This has never been fired, but should be very accurate. Receiver face was squared and the barrel bedded with blue loktite, barrel nut torqued at 40lbs.
200 Lapua cases.
300 Starline cases.
150 PPU cases.
4 pounds of CFE BLK
All that is needed to finish this, is the Superlative adjustable gas block, it needs the clamp on version, because Mcgowen did not dimple the barrel. I have 990$ invested in this project.
Looking for 800$ shipped, obro.
More pictures by request.