Newbie reloading case question

I would at least run the expander ball thru it.

Just a thought... I would try chamfering the inside and outside of the neck mouth before running the expander thru it or sizing the new brass. Lots of brass has buildup on the case mouth from forming the new brass. I always remove it with a chamfering tool before sizing it. Might help.
 
Sounds good. I'll chamfer and expand, load, and shoot. Once I reload these again, i'll see if that changes anything. Doubt it, but don't have to worry about it right this moment.
 
Warning! This thread is more than 9 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top