DLJ6
Well-Known Member
Thanks for sharing, Ive had my finger on the trigger to order a gauge for a while but just can't seem to pull it.
Which gauge did you get and are you happy with it?When I got my concentricity gauge I measured some .300 win mag loads that I just finished. The worst one was .002" runout while most were less. I thought that I wasted money on the gauge or it did not work. For the next hour or more I was digging out boxes of reloads and some old factory loads from 20 years ago. The gauge worked just fine. I found that rotating the shell three times while seating the bullet helped. I also found one set of .308 dies just needed to be replaced.
I got the RCBS. If I were to buy it again, I would probably get the Sinclair. That's just due to it having rollers bearings instead of a V slot to roll the round in.Which gauge did you get and are you happy with it?
Thanks for sharing, Ive had my finger on the trigger to order a gauge for a while but just can't seem to pull it.
Thanks for that, it made me belly laugh.....we need to remember what the weakest link in the chain usually is, don't we!I'm definitely "NOT" going down that "rabbit hole"……I have too many mental issues!
I have a method…..approved by the SWAG system of hand loading. I go through the usual loading steps, minus a few that you guys use, however when seating the bullet……I fully seat, rotate the loaded/seated cartridge 180 degrees, then seat again.
I can't attest to this as helping minimize runout or just screw things up twice! But, I get groups about as good as possible considering……the shooter, the cartridge, the load, the rifle/scope combination, and felt recoil which may fall into the shooter category. I constantly get one hole @ .375"…..until I fire the second shot! memtb