Gunsmith to install banded front sight

[letzhunt]

I'm looking for a gunsmith who can properly attach a banded (likely NECG) front sight on a .458 win mag that's had the barrel cut to 20". Close is better but anywhere that does good work. I'm in NE Indiana. I can have the barrel removed and just send it for the sight install with the barrel marked at top dead center.

 

[Brathany]

Do you have the sight?

 

[letzhunt]

Not yet? My rifle is at my riflesmith to get the barrel cut. He does great work but doesn't install that kind of front sight. I was planning on having him just reinstall the original sight ramp but I really prefer the banded style.

 

[Brathany]

The concern is the outside diameter of where the barrel is cut and the internal diameter of the sight.

 

[letzhunt]

Understood. I measured at the 20" where it will be cut but can't find where I wrote that down.. And it's at the Rifle smiths so I Cant check to see the measurement. don't even know if I will be able to find one large enough in diameter.

 

[Brathany]

When it gets back, measure and then call the sight company to see if it's feasible. Really a non banded sight would be much easier to mount. No diameter concerns.

 

[Sergeant Stadanko]

JRH Advanced Gunsmithing in Carson City, NV. (Jack Huntington) He does that type of work all the time. Awesome gunsmith.

 

[letzhunt]

thanks for that lead.

 

[Wilderness Blacktail]

Ive read a number of chapters/articles where they state that you take some measurements in the vicinity you want the sight, buy the band, slide it up tight, mark it and cut the barrel to that length. Then reinstall the sight n sweat it on. Or something along those lines.
It seems like any decent smith could do it?