I know CLR will damage bluing but wasn't sure about Carb-out. Thanks
Factory rounds sticking?
- Thread starter WA Coyote
- Start date
Help Support Long Range Hunting Forum
Varmint Hunter
Well-Known Member
Eric Cortina used CLR regularly and showed a LARGE empty container that he finished up with on one of his videos. He said that even though he never had any problems with any barrels that he cleaned with CLR, he stopped using it because it voided the warrantee from the barrel manufacturer.
I submerged a SS brake in CLR. It was my intention to leave it in for an hour or so, but I totally forgot about it. The next day, I remembered about the brake and removed it from the CLR. All the built-up carbon just floated off the brake. The brake looked slightly different in the finish but it was fine. I've repeated this process without issue.
I think CLR is reasonably safe for use and would definitely use it to attack carbon that is resistant to removal by other methods.
I submerged a SS brake in CLR. It was my intention to leave it in for an hour or so, but I totally forgot about it. The next day, I remembered about the brake and removed it from the CLR. All the built-up carbon just floated off the brake. The brake looked slightly different in the finish but it was fine. I've repeated this process without issue.
I think CLR is reasonably safe for use and would definitely use it to attack carbon that is resistant to removal by other methods.
I have some Dead Air Mask cans. I pull the internals and let them soak in CLR. They look like new when I take them out a few hours later. And... using brush / patch method (borrowed from Erik) I've had good results.
I've used CLR in an ultrasonic cleaner to remove a bunch of carbon out of a Titanium suppressor. The finish was marred, but the can was CLEAN when I got done.
I'll be honest, I haven't even owned a bore brush in over a decade, and haven't ever felt the need for one. I've been through about a half dozen custom barrels in that time and never dealt with any "carbon ring" symptoms, let alone a sever case of CARBID19. Sounds like I'll need to pick one up and get to work.
Film at 11:00.
I'll be honest, I haven't even owned a bore brush in over a decade, and haven't ever felt the need for one. I've been through about a half dozen custom barrels in that time and never dealt with any "carbon ring" symptoms, let alone a sever case of CARBID19. Sounds like I'll need to pick one up and get to work.
Film at 11:00.
