Ever seen a spot like this in a barrel?

[WEATHERBY460]

New Savage 6MM Creed. I cleaned before shooting and cleaned after I shot 2 rounds thru it to see if it went away. I sort of don't think it's copper. What are your thoughts?

 

[ShtrRdy]

Looks like a stain. Run a couple dry patches through and see if it's still there.

 

[WEATHERBY460]

Yes it's still there. Looks like it's on top of the filling in the first picture.

 

[Gabe22BR]

Clean that copper spot out, should be clean then…

 

[Tiny Tim]

Don't suppose you looked at it prior to shooting it? Looks like you should have felt it during cleaning the first time. I'd think it would have snagged a patch if it was there prior to shooting.

 

[yogibearmech]

You can try this. It had my 6 Dasher barrel so shiny had to turn the light on my bore scope to low from glare.not sure it will get it but might be worth a try

 

[Kmccord]

Hmm, if a new barrel, is this a chrome moly barrel?? I wonder if it is a rust spot, it sort of looks like what I have seen in my Bergara. I had cleaned it with Bore Tech Carbon cleaner and put several dry patches down the bore to remove residue and put back in the safe.. A week later I went to shoot it and noticed rust on the thread cap, borescoped it and found rust spots in the barrel. It required me using JB Bore Paste to remove it.

 

[Brathany]

You can try this. It had my 6 Dasher barrel so shiny had to turn the light on my bore scope to low from glare.not sure it will get it but might be worth a try

This system. I've cleared out my cleaning bench of most anything else.

 

[Mikecr]

https://www.amazon.com/J-B-Non-Embedding-Bore-Cleaning-Compound/dp/B0018L9UOW/?tag=lrhmag19-20

 

[Rosebud]

Looks like a blemish in the steel when the barrel was made. If it shoots well,to your standards just clean the copper off and forget about it.

 

[Culpeper]

If it's shooting fine don't worry about.

 

[cajun]

How does it shoot? I would be afraid to look in my savage factory barrel lol. But it shoots very well.

 

[skipglo]

You can try this. It had my 6 Dasher barrel so shiny had to turn the light on my bore scope to low from glare.not sure it will get it but might be worth a try

Great stuff!