• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Bearing Surface Length Measurement Question

Well, I'll concede that the Sinclair does have the same hole IDs as The Buhay/BSC. Just measured best I could with calipers(don't have pin guages here). Looks like 24cal holes are .239", and 26cal holes are .260".

Seems like these are larger than typical bore diameters, but not as close to 'caliber' as I assumed(there's that dirty word). The Sinclair tool is good.

Hope I didn't mess ya up
 
Warning! This thread is more than 18 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Similar threads

J
Bullet bearing surface question
Replies
11
Views
4K
Mikecr
Mikecr
haisardao
Bullet bearing surface
2 3
Replies
31
Views
3K
QuietTexan
QuietTexan
TC338
6.5 bearing surface
Replies
0
Views
721
TC338
TC338
J
Bearing surface tolerance
Replies
10
Views
3K
Mikecr
Mikecr
Mogollon Hunter
Bearing surface and pressure
2
Replies
24
Views
2K
Mogollon Hunter
Mogollon Hunter

Recent Posts

Top