• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Ballistic help for a newb?

Give me all this info and I can help
I will find your bc
I don't need it
Also need compass direction
Temp
Presure
Any angle
 

Attachments

  • IMG_6293.png
    IMG_6293.png
    208.2 KB · Views: 13
I'll just throw this out there...

I saw where your adjusting the scope in MILs.
But you're measuring the drop in inches or MOA..

Do yourself a favor and get a metric tape measure.
Makes it easier than trying to jump back and forth. 😉
 
If you didn't find your impacts at 800 yards, how do you know you were missing the target low? I think you've got to get on paper before you start making corrections.
Also hard to believe the MV for your 300 WSM is only 3050fps for a 138gr bullet?
 
Last edited:
If you didn't find your impacts at 800 yards, how do you know you were missing the target low? I think you've got to get on paper before you start making corrections.
Also hard to believe the MV for your 300 WSM is only 3050fps for a 138 bullet?
I walked up to the steel at 800 yards and saw my impacts (see the photo) and my hold. I could not see the impact through the spotter or scope (15x) That MV is 3220 at 65 degrees or so. I'm going to Doppler it again this week.
 
I you are indeed 16 inches low after dialing 5.3 mils (which is what my calculator shows as the required up for 800 yards) and the other data you provided , your new G7 BC is .175

The new required mils is 5.8. I used 65 degrees, 1000 ft of elevation and 30% humidity
 

Recent Posts

Top