- Joined
- Jan 29, 2017
- Messages
- 29
Hey all,
Just finished up a riser system for the AutoTrickler V4, if anyone is interested.
Current setup:
Note:
- For folks that are running the AutoTrickler V3 system, I also have the below design available, just with a different top.
- Not pictured is a thumb screw that I've added to the rear tab to enable tilt adjustment, based on the instructions about shimming to adjust the powder flow from the small tub.
Cost: $100.00 (shipped USPS Priority within the 48 included in price)
Thanks,
Just finished up a riser system for the AutoTrickler V4, if anyone is interested.
Current setup:
- AutoTricker v4
- A&D FX-120i Scale
- Base support for either the Factory Circular scale pan or the Area 419 triangle scale pan (just specify on request).
Note:
- For folks that are running the AutoTrickler V3 system, I also have the below design available, just with a different top.
- Not pictured is a thumb screw that I've added to the rear tab to enable tilt adjustment, based on the instructions about shimming to adjust the powder flow from the small tub.
Cost: $100.00 (shipped USPS Priority within the 48 included in price)
Thanks,
Attachments
-
AT4 Riser - Back.jpg213.1 KB · Views: 735
-
AT4 Riser - Standard & 419 - 1.jpg483.1 KB · Views: 625
-
ATv4 Riser - Area 419 Pan - 1.jpg565.7 KB · Views: 827
-
ATv4 Riser - Area 419 Pan - 2.jpg456.5 KB · Views: 711
-
ATv4 Riser - Standard Pan - 1.jpg507.2 KB · Views: 768
-
ATv4 Riser - Standard Pan - 2.jpg527.6 KB · Views: 688