Thanks Sir. It'll be nice seating those high BC bullets close to the lands
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
7-08 Help
- Thread starter sextonds
- Start date
Help Support Long Range Hunting Forum
Thanks Sir. It'll be nice seating those high BC bullets close to the lands
jimbires
Well-Known Member
what makes the difference in tikka actions is the bolt stop and mag box .
Anybody loading H4350 over 140's? I'm loading some up. Planning to start at 45 and go up. Hoping to find what I'm looking for on the low side. Don't really want to crush powder. I have the bullet seated as far out as my magazine will allow
Heck, I'll throw my .02 cents worth in, H4895 powder and 140 Bergers worked great for me. Had good luck with IMR4064 too. Now I'm testing the Berger 150's.
Did you try H4895 yet?
H4350, RL16 and RL17 have worked great for me with 150gr bullets and up. You'll get more speed than Varget or 4064, at least a 100 fps or more..
Yes. Best group was .9" I think. I posted results a few pages back
Dang I missed it. Whats your COAL with H4350?
Alright, did you crunch any powder yet?
I don't believe so. I pulled one loaded with 46gr to see and didn't seem like it was. I then worked on up to 47.5 and stopped there
If you have the bullet out a bit you should be fine. I'm crunching powder but with a 162gr A-Max and 168gr Classic Hunter and no pressure, I hear the kernels crunch as I seat the bullets.
Outdrmn
Well-Known Member
Same here, little crunch'n at the end of the seat.
162 eldx, 39.2 gr 4166
Bobcape
Well-Known Member
Have you tried using a drop tube? It makes a difference on how the powder will fit in the case.
Bob
