Looking for load data for the .405 Win using 250 grain Hammers.
.405 Winchester load data
- Thread starter Rosebud
- Start date
Help Support Long Range Hunting Forum
100percent
Well-Known Member
Did you ever load the 250's? Looking for something besides the 300 grain hornady
Yes, I'm using Norma 201, 55 grains @ 2200+ FPS. That's all my shoulder will allow. Could get close to 2600 if you're willing to be punished.
100percent
Well-Known Member
No sir! I've been punished enough!!!
Thank you for the information. I'm working on finding a die set to reload for this beast!
Thank you for the information. I'm working on finding a die set to reload for this beast!
I think I may have some brass saved, but it sure isn't from my favorite manufacturer.
Along the same lines, I have no desire for more pressure than the factory 300gr loads.
Along the same lines, I have no desire for more pressure than the factory 300gr loads.
Left Hand Dave
Well-Known Member
I have been working on loads and getting up to 2600 FPS but accuracy was not there. Currently working around 2500 FPS but I think my scope may have went south. Going to switch it out and see what happens.
Only brass maker I know of is Hornady! My accuracy is scary good. The bullets put a serious whacking on the two deer I shot last year. 250 Shock Hammer.
If you can't find any I'll send you 20 or so of them. Just pay shipping.
Me too.
