30 WOLF

[DANTEC]

can you put a picture of a 30 WOLF with a 338 LM side by side to compare , since we speak of the 30 WOLF I have see any picture of the cartridge

good shooting

DAN TEC

 

[Nighthawk]

STL, do you know if the dies will work on an RCBS RockChucker?

 

[STL_Shooter]

Dantec,

I don't have any straight .338 Lapua cases anymore - they've all been Wolfed...

Nighthawk, I use the old Rockchucker all the time to load for the .30 Wolf...

[ 08-19-2003: Message edited by: STL_Shooter ]

 

[Nighthawk]

I have a RockChucker as well, but S1 told me that there isn't enough room and suggesed that I get a larger one or a Hornady. I personally would like a Redding progressive one if it will work. Do you know if the dies will work on that? Let me get someting straight, if I buy and use the dies that S1 makes that is all it takes to convert .338 Lapua cases to Wolf cases other than turning necks?

 

[STL_Shooter]

Well, again, he's seen me use a regular Rockchucker a hundred times to load for the Wolf - he must have been...uh...distracted...

Nope, you must have a way to neck down from .338 to .308 caliber. S1 uses three downsizing dies made by RCBS, I think, to get the necks down in three steps. You could do the same thing with three type-S bushings in a sizer made to accept them...

 

[Nighthawk]

STL, do you think I could give you a call sometime here? I think it would be a lot easier on us and Len.

 

[STL_Shooter]

Email me your number at [email protected]...

 

[Nighthawk]

STL, you have mail on the way.

 

[DANTEC]

to STL_Shooter

Ok but can you make a picture with a 220 SMK or a 240 SMK if youhave no 338 LM available

good shooting

DAN TEC

 

[Chandalar]

Does any one know if the 253 grain- 30 cal. powder tungsten long range bullets are still available?