270 Win Found My Recipe

How many grains up or down were the other loads and how did they shoot? Reason I'm asking is Imr4350 is a great powder but velocities will change with temperature. I would shoot that good load in different conditions make sure it doesn't fall apart.
That's what I'm thinking. I recently went through the same theming the last couple days. Out of five different charge weights the one in the middle of the range was half inch and the rest were two to almost five inches. So one really good group makes me nervous about that load. My other one was very good throughout all the charge weights most were approximately 1/2" out of 7 different charge weights the two worst were about 1 1/2" spread. So my thoughts are it was very consistent through the ladder test unlike the one the other day where I only
Had one good group and rest were bad.
 
Wow, in over 50 years of reloading of more than a dozen different calibers, several different powders, several different weights of bullets, and different manufacturer of primers, I have never shot a 5 inch group at 100 yds with a rifle or at 25 yds with a handgun.
 
That's what I'm thinking. I recently went through the same theming the last couple days. Out of five different charge weights the one in the middle of the range was half inch and the rest were two to almost five inches. So one really good group makes me nervous about that load. My other one was very good throughout all the charge weights most were approximately 1/2" out of 7 different charge weights the two worst were about 1 1/2" spread. So my thoughts are it was very consistent through the ladder test unlike the one the other day where I only
Had one good group and rest were bad.
The max load is 55grs. I went down 1% from there for 10 steps down to 49.7grs I used excel to do my calculations and rounding. The lower I went the worse it got. IMR4350.
 

Attachments

  • IMG_6809.jpeg
    IMG_6809.jpeg
    234.5 KB · Views: 8
How many grains up or down were the other loads and how did they shoot? Reason I'm asking is Imr4350 is a great powder but velocities will change with temperature. I would shoot that good load in different conditions make sure it doesn't fall apart.
The max load is 55grs. I went down 1% from there for 10 steps down to 49.7grs I used excel to do my calculations and rounding. The lower I went the worse it got. IMR4350.

Attachments

  • IMG_6809.jpeg
 
Top