-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Bergara 22-250
- Thread starter ByronP
- Start date
Help Support Long Range Hunting Forum
Critter Picker
Well-Known Member
Help us out here, what loads have you tried?
have all that at home
Sealesniper
Well-Known Member
I would start over.
Remove scope, rings and bases.
Remove barreled action.
Re-install everything making sure barrel is floating, recoil lug correctly positioned, screws not too tight and not contacting action.
Same with base and rings. What scope? If scope is questionable, mount it on a .22 and sight in then bump it and shoot again. make sure not an issue in scope. If scope good, re-install and shoot.
If still no better than 1.5 moa, check crown for burr.
After that, send back to Bergara.
Remove scope, rings and bases.
Remove barreled action.
Re-install everything making sure barrel is floating, recoil lug correctly positioned, screws not too tight and not contacting action.
Same with base and rings. What scope? If scope is questionable, mount it on a .22 and sight in then bump it and shoot again. make sure not an issue in scope. If scope good, re-install and shoot.
If still no better than 1.5 moa, check crown for burr.
After that, send back to Bergara.
highfinblue
Well-Known Member
Staball 6.5 and Hornady 68 grain bthp's are loved by mine. Definitely want to make sure all your screws are torqued to factory specs, and you're shooting bullets the barrel with stabilize, but they are guaranteed to shoot MOA or less if I'm not mistaken. Mine will not stabilize any bullets heavier than the 68's that I've tried, however, but it will put five of them in a ragged hole at 100 yards.
- Joined
- Jan 26, 2015
- Messages
- 1,847
@Sealepretty much covered it. Also make certain nothing is binding as you torque the action screws (recoil lug, bottom metal, etc...), and make sure it's seated firmly against the recoil lug as you do.
Factory ammo or reloads?
Factory ammo or reloads?
Upsidedownjack
Well-Known Member
- Joined
- Dec 28, 2017
- Messages
- 302
jerry moore
Well-Known Member
my 1st Bergara didn't group talked with a smith he told me to set act screws 55 f lug 1st then 55 on tang rifle started shooting the gun smith was at bergara
Upsidedownjack
Well-Known Member
- Joined
- Dec 28, 2017
- Messages
- 302
And after, how did it/you Shoot?
jerry moore
Well-Known Member
i own 3 bergaras only one i had trouble with when I adj the act screws rifle shot sub moa I start tang screw then tighten lug to 55 then finish tang to 55 I hope this helps if not call ber get ship label the reason I talked to g s I sent rifle back they returned it it still grouped 1.5 called & returned it again that's when I spoke to g s ps I really like bergara
Thanks
