• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

6.5 Grendel

S

Shane Lindsey

Well-Known Member
Joined
Jul 13, 2010
Messages
3,937
Just picked up a Sanders armory 6.5 Grendel upper. Took it to the range and it would not shoot better than about 5 MOA with Hornady 123gr Black or the 123gr SST.

It seems a little undergassed, as it would not consistently lock or feed. Will this affect accuracy as well? Can usually diagnose a bolt gun. Not new to ARs (issued) but never had to trouble shoot them, jsut handed them to the armorers.
 
It sounds like its under gassed.
Sometimes it could be the gas block alignment...causing the port to be slightly closed
Sometimes it could be the gas port (too small)...but Sanders is usually set up correctly...unless a drilling bur is blocking the port.
Sometimes it could be the buffer/spring combination... if it was being used with a different barrel/cartridge configuration.
Even the bolt lugs fitting tight in the barrel extension may cause a delayed release.
I've hand cycled a tight one before 40-50 times, slamming it into battery to "break-in" the lug abatement.
 
Typically my grendels have been over gassed and I've added adjustable gas blocks to tune them down......like Roughrice said check gas block alignment and other items he mentioned. Lube the heck out of it and cycle it till everything is moving nice. The last one i built was tight on lock up but it "wore in" with oil and hand cycling. I'm guessing it had a small burr on it. Not 100% sure on accuracy, but I'd say it affects me shooting accurately more than the gun.
Good luck
 
Roughrice said:
It sounds like its under gassed.
Sometimes it could be the gas block alignment...causing the port to be slightly closed
Sometimes it could be the gas port (too small)...but Sanders is usually set up correctly...unless a drilling bur is blocking the port.
Sometimes it could be the buffer/spring combination... if it was being used with a different barrel/cartridge configuration.
Even the bolt lugs fitting tight in the barrel extension may cause a delayed release.
I've hand cycled a tight one before 40-50 times, slamming it into battery to "break-in" the lug abatement.
Click to expand...
I did check the alignment of the gas block. Looked slightly off, so I re-centered it.

Would this affect accuracy like this though? It is the Type II Grendel, FWIW. 4-6" is just not acceptable though.
 
Rings were torqued to 25"# per manufacturers recs. American Defense recon mount.

May put another scope on and aee it that is issue.
 

Similar threads

D
6.5 Grendel Decision
3 4 5
Replies
65
Views
17K
5.56×250
5
Holycity73
6.5 grendel...
2
Replies
16
Views
12K
MudRunner2005
MudRunner2005
J
6.5 Grendel
Replies
5
Views
3K
Tamarac
T
R
6.5 grendel
Replies
7
Views
18K
joseph
J
M
6.5 Grendel Upper
Replies
6
Views
4K
DVLDOG6.5
D

Recent Posts

Top