dukslayer4051
Active Member
As per the instructions
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
7 prc
- Thread starter dukslayer4051
- Start date
Help Support Long Range Hunting Forum
dukslayer4051
Active Member
Where did u rent it from and what tools are required?
dukslayer4051
Active Member
Im curious about what steps and how and what tools. I'm worried I'd mess up my gun, I'm no gun Smith
dukslayer4051
Active Member
I full length size my brass
brcfo_outdoors
Well-Known Member
Are you having problems with both rifles? I know from first hand experience that Bergaras have super rough chambers, I had one in 7RM and it was a nightmare, especially after it warmed up a bit.
What is your load info? bullet, brass, primer, powder?
dukslayer4051
Active Member
Hornady brass
H1000 or Ramshot LRT
Hornady eldx 175gr
Federal 215
It doesn't matter how many grains of powder even minimum charge it has the same issue
I would get a Hornady headspace comparator and see how much you are pushing the shoulder back from fired brass. You may not be resizing the brass enough. Do resized rounds chamber easily just not extract?
dukslayer4051
Active Member
They cycle just fine until fired
That hard bolt lift part is what made me comment. I always get a little drag along with clickers, but not "hard" bolt lift.
Hard bolt lift, if truely hard, with low charges may be a secondary issue.
Trim length? Carbon ring?
No matter right now. You KNOW clickers are an issue and the resolution is well documented. Rent the AW reamer and get the clickers taken care of. If there is a secondary issue, it will be easier to identify as a single variable.
Similar issues for me. Factory Hornady ammo ran fine. As soon as I switched to Peterson brass I started having bolt lift issues although I did not have any stuck cases. After lots of research on this forum, I rented an AW reamer from charliehorse27 (on this site). The process is pretty straight forward and does not require advanced tools or advanced machining skills. The process was nerve-racking for me but I followed the instructions closely and went slow. The hard bolt lift was fixed and my hand loads shoot beautifully.
Lone Peak Arms Fusion TI, Proof Carbon 24", Trigger Tech Diamond, HNT26, Razor LHT, ACE muzzle brake.
Lone Peak Arms Fusion TI, Proof Carbon 24", Trigger Tech Diamond, HNT26, Razor LHT, ACE muzzle brake.
Buzzsaw
Well-Known Member
*** is a "clicker"?? I've been reloading 55+ years, never heard of it/them
crashlanding
Well-Known Member
https://www.wheeleraccuracy.com/videos. Scroll down, Alex explains it clearly at least for me
