Yes I watched that exact video.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Muzzle break/ side baffle
- Thread starter SHEDKING
- Start date
Help Support Long Range Hunting Forum
You should be fine.
waveslayer
Well-Known Member
Good luck! Most barrels are threaded differently on where they start the cuts for the threads, so timing has to be done by washers. Or a crush washer, depending how much you torque it.
Or go with the APA breaks that self time and work extremely well
Or go with the APA breaks that self time and work extremely well
I measured the diameter of the barrel and Nathan turned the brake down in a taper like yours before shipping it. The fit was perfect, although I needed a shim to time it.
I, too, measured my barrel's OD so that Nathan could adjust accordingly. However, I did not ask him to taper it because he no longer cerakote, so I had my GS do it to match my barrel, as shown in #12.
Last edited:
Partly why they call them...Crush washers....you are far better off getting a Nut to go behind the brake...and throw the crush washers away
