Flintlock shooter
Well-Known Member
I mounted mine to a piece of 2" square tubing that I can put in the receiver hitch on my truck for use anywhere. In my shop I just clamp the square tubing in my bench vise to hold it when I need to use it.
Barrel Vise Mounting options
- Thread starter MighteyWhiteHunter
- Start date
Help Support Long Range Hunting Forum
TontoDean
Active Member
If you don't yet have the barrel vise, Short Action Customs has a vise that mounts on an Arca style base that you leave attached to your bench.
Mine is Identical except painted florescent orange
Kmccord
Well-Known Member
I have the Short Actions Customs barrel vice and it fits on the arca rail, remove the vice and you have the work bench with very little space used up.
I just put the barrel vise in my regular shop vise. When I'm done it goes back in the tool chest.
azsugarbear
Well-Known Member
I have a flush mount inline fab quick change and have a Hornady LNL, Lyman All-American 8, a vise, a Lee Challenger, a bench grinder and a cut saw for converting brass. Multiple holders around my basement where I store what is not in use. Was going to mount my Viper Barrel vise on one too, but so far, holding it in my vise works. I like the idea of mounting low on bench, seen a few smiths do that.
Dry wall tape or some old leather strapping.
MighteyWhiteHunter
Well-Known Member
Awesome Ideas everyone I appreciate all of it. The Inline Mounting stuff has me intrigued. I will have to look into that further.
M1A1ABRAMS
Well-Known Member
I don't believe anyone mentioned mounting to the wall studs. Just another option depending on shop.
Mine is mounted on an Inline Fabrication plate. I'll post some pics later today.
Last edited:
K9TXS
Well-Known Member
I have a piece of leather that I dust with a rosin bag like baseball players use. Wrap the leather around the barrel once and clamp it down. Never slips.
dennisinaz
Well-Known Member
I clamp mine to the bench with pistol grip style wood clamps ( Irwin). I use paper towel or powder sugar for grip
