Recent content by 19 Badger

Like a dumb dumb, I deprimed my finger. Lol

I was talking a a fellow one day at a local range about accuracy and just rifle small talk etc. He proceeded to pull out his wallet as if he was going to show me a pic of one of his grandchildren or something. Instead, he pulled out a little piece of a target with a very small group (basically...

Pure Precision is awesome...

Have only taken a couple mule deer and 1 antelope with the 110 Hunters in my .260AI, only 1 went a few steps. They are the easiest bullets I have ever done load development with in 4 guns so far. No complaints here....

Welcome from Central Ca.

I have the Vortex you are asking about but I still prefer my Sightron SIII 6-24x

Will a factory round chamber in it? If so, chamber it and shoot it to get a good idea of your chamber size from base to shoulder datum. It will probably take a couple firings to completely fireform to your chamber. I would do this before I started running your sizing die in blindly and...

Just to be sure, are you measuring the fired cases with the primer removed or still in the case?

I shoot the 140 Accubond with 7828 @3350 in a factory Accumark. Great bullets, very hard to come by the last couple years.

Welcome from central Ca....

Awesome news for the guys at Hammer Bullets. I wish my .270 wby came with a faster twist from the factory... Like an 8tw.

Welcome from Central Ca. Awesome forum, great people..

Brownell's has been putting them on their site lately for about $80 per 1k.

I have shot the BR 4's and the 450's in a 6.5cm and .204 ruger with same load and found zero difference in performance. I treat them as one and the same... I typically try to stay away from top end loads so my primer pockets go quite aways....

I only use 7.5 remingtons and BR 4 CCI in my .204 Ruger. They have a much thicker cup....