V4 Autotrickler straw modification

[Petey308]

Thanks for your reply.We need more info to understand what the improvement is.
Len

Unfortunately I can't post a video directly on here, otherwise I'd show you my own videos.

Essentially it's just a 3d printed reducer nozzle that goes over the trickler tube, with internal spiraling that helps draw the powder out but also allows it to drop one kernel at a time.
MIT creates a more consistent trickle and allows for faster overall suspending and with little to no over/under throws.

Without it, it can be a pain to get the angle shimmed just right to get it to trickle properly and sometimes it still ends up spitting out too many kernels at the end and gives over-throws.

 

[Coyote Shadow Tracker]

I just be not educated, but still don't see what is the improvement and the benefit???

 

[Petey308]

I just be not educated, but still don't see what is the improvement and the benefit???

It's the same concept with all the outserts out there for the RCBS, Frankford Arsenal, Hornady, etc dispensers. It just makes the trickler tube work more efficiently and consistently.

 

[Coyote Shadow Tracker]

It's the same concept with all the outserts out there for the RCBS, Frankford Arsenal, Hornady, etc dispensers. It just makes the trickler tube work more efficiently and consistently.

Thanks

 

[josh_127]

I bought the tip from jthor and a spacer kit from Drhorsepower who's kid was making them....both of those combined makes my v4 so accurate it's nuts. I use n570...h1000,h4350,br2,varget,h4895, ramshot tac....you have to play with the spacers a bit to figure out the best for each powder but they do make a difference.

 

[171farm]

Ok now spacers? What are spacers

 

[josh_127]

Drhorsepower's kid makes these plastic donuts that are different height that go under the back of the hopper...they change the tilt and how the trickler operates...works very slick and between these and the straw tip my v4 is spot on...very rare does it over throw...even with light loads