Wondering how people that use the Hornady Lock-n-Load bushing store their dies? They don't fit in the factory cases anymore. I can come up with some ideas but thought if someone has been down this road before I could save some time. Thanks.
Storage for dies w/lock n load bushings?
- Thread starter 338weatherby
- Start date
Help Support Long Range Hunting Forum
I'm using the lock n load storage system made by inline fabrication. Im also using the ultra mounts, and quick change bases. Really is nice to swap presses and other tools in seconds with two wing nuts.
Thanks. I forgot about In-line Fab.
59FLH
Well-Known Member
For storing other Mfg dies Hornady sells empty boxes with a blank label. If necessary cut out the shell holder post.
Those look nice. Might have to get a couple.
Most of my dies will fit in the original box upside down with the lock n load attached to the die.
Forster also sells empty, unlabeled die boxes as well. Since I use a co-ax press the die locking rings are larger so I have all of my non Forster dies stores in them.
DDWing
Well-Known Member
I store all of my dies in the original Hornaday box that they come in, with the Lock & Load bushings attached, and they all fit fine.
I haven't used my Hornady dies yet with the bushings. The RCBS, Lee, and Redding will not.
Trooper1
Well-Known Member
^x2
General RE LEE
Well-Known Member
My Hornady dies fit in the box with the bushing installed.
