Seriously considering cutting my barrel 🤔
- Thread starter crazymonkey
- Start date
Help Support Long Range Hunting Forum
wilehunting
Well-Known Member
More muzzle blast, more recoil, less velocity
I agree with wilehunting, there are definitely some trade offs. But, I think it depends what you are using the rifle for. Do you plan on using a suppressor? Distances, box blind, etc.?
Randominator
Well-Known Member
Cut it. Even in rifle configuration it will be easier to handle. 17" on my 7-08.
Don't really need to run as a rifle as I already have A custom 7-08 rifle. Just like options. Yes I can run a suppressor on the end but need to keep enough lenght to keep it safe. A light 120 ttsx should still net me a hundred yard pistol for elk depending on load workup.
Randominator
Well-Known Member
I run a 140 grain Remington Core-Lok at 2605 fps. That should take care of an elk.
If you are willing to accept the trade offs, I'd say cut the barrel. It should work well for your intended purpose. I do think the muzzle blast will be tremendous without a suppressor. Let us know how you make out.
KYODE
Well-Known Member
there are a lot of handguns with 14-15" barrels, even some with muzzle brakes. This is a specialty handgun forum section. Muzzle blast is of little concern lol.
My 7-08 is a factory 15" encore. I don't see anything but a plus to it. Your rifle barrel already has the long forend spacing, which is a big help.
My 7-08 is a factory 15" encore. I don't see anything but a plus to it. Your rifle barrel already has the long forend spacing, which is a big help.
I don't think it will be to crazy bad for blast. I've already got a contender with a few barrels . The 10 inch 357 harrett is a blast . Then the loudest gun I've ever shot is my striker in 22-250 . I haven't shot the encore with the 204 ruger barrel yet . I'm just missing the Xp100.
Attachments
If done had it hacksawed off, crowned & been shooting it !!!
I'd cut it to the twist rate..
Clem Bronkoski
Well-Known Member
Cutting a barrel is really easy to do. Take a tubing cutter and scribe a line where you want to lop it off. Using a hacksaw blade only carefully and slowly cut and rotate as you go until you get all the way thru. Patience is the key to a good job.
With your 7-08 barrel, take 2" or so of a 1" dowel and drill a 1/4" hole thru the center and push a 1/4" dowel section thru it gluing it in place.
Cut 2" squares of 400 grit emery paper and push it over the dowel and the other end into a drill and work the face. Once you got it polished out get a i/4" cap nut and appropriate bolt. Put the bolt in the drill, apply some valve grinding compound and put your crown on the muzzle.
With your 7-08 barrel, take 2" or so of a 1" dowel and drill a 1/4" hole thru the center and push a 1/4" dowel section thru it gluing it in place.
Cut 2" squares of 400 grit emery paper and push it over the dowel and the other end into a drill and work the face. Once you got it polished out get a i/4" cap nut and appropriate bolt. Put the bolt in the drill, apply some valve grinding compound and put your crown on the muzzle.
