Re barrel carbon wrap 6.5-284 (sub 0.4 moa)

MontanaJack

Well-Known Member
Joined
Jun 11, 2010
Messages
159
I've got a Christensen Ridgeline 6.5-284 with a shot out barrel. Contacted Christensen to replace it, but they don't offer that services. Guess your supposed to throw them away and buy a new one!! Lousy customer service!!! Got that out of my system. Any suggestions re/ where I should send this door stop to get a new barrel? It is the Ridgeline, Model 14 with the 26", threaded carbon wrap barrel and I want to replace like with like. This needs to be sub-MOA after the replacement. The old barrel still shoots slightly over 1 MOA, but I'm a one hole kind of shooter. Don't like my rifles shooting like shotguns!! Thanks,
 
For a relatively simple barrel replacement, you ought to be able to find a "local" smith that can assist you in getting the right barrel and fitting it to your action and stock.
This would be my first choice. I am lucky to have at least ten reputable GS within an hour's drive from me. I have one two miles from my house. My go-to GS since 2003 is half an hour's drive.
There are Sponsors on this site that can fix you up.
And you will receive a couple dozen recommendations from members.
Good luck. 👍🎅
This would be my second choice.
 
If there's enough meat on the shoulder without interfering with wrap, a good GS can rechamber same caliber. Had my GS reset my 6CM and kept on shooting although it wasn't carbon wrapped. Check with a GS first.
 
Oregon Mountian Rifles in Billing Mt has done a few for a friend that shoot very well. Fast also.

Hal
 
Top