• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Once Fired Brass Prep

MattKSo please clarify that you remove the expander ball/decapping pin and do not need to use it because you are using a bushing die to set the neck tension/diameter?

ajkellerusmc, yes, that's right. It works for me with turned necks (6.5x55 improved and 300 Norma improved) and un-turned necks (260 Rem and soon 6 mm CM). If I happen to have a neck which is dinged up, then I use neck turning expander mandrel to straighten it, as mentioned by aushunter1 (I think).
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top