Long range verification

[sqearl]

Hey guys need some help. I've just gotten my new suppressor spun it onto my Christensen 300prc. I've dialed it in dead nuts at 100 yd. Then I shoot it at 500 yd. High and right. I try at 1000, high and right. Now the elevation I can dial in. The right has me baffled especially when it is zero at 100. Does anyone have any insight or advice I could use. Thank you in advance

 

[WeiserBucks]

Wind?

 

[dogz]

right hand twist..........

 

[waspocrew]

Like was pointed out in your other thread - likely spin drift.

 

[Rick Richard]

Wind, maybe some spin drift and shooter error that is magnified at that distance? Only guessing at this point.

 

[CaneBrake]

How much high and right are we talking? How did you obtain the muzzle velocity you are plugging into your ballistics calculator? At 500yds you will start to see some significant spin drift, and at 1000yds it drifts quite a bit.

 

[sqearl]

I used lab radar initially. Without suppressor. Now what I was working on is validation. And with what I found I was going to input it into a sig kilo 2400 ABS

 

[CaneBrake]

I used lab radar initially. Without suppressor. Now what I was working on is validation. And with what I found I was going to input it into a sig kilo 2400 ABS

As I mentioned in your other thread. The suppressor will increase your muzzle velocity which is throwing your dope off. You need to measure MV with the suppressor on. Or you could go the long way around and confirm dope at range and then use a MV correction to match the dope in your calculator.