I need help with a .300 prc build.

[Will.284]

I to have been looking at the 300 prc and 338 edge , it's a hard decision as I'll be hunting with either one. Edge dies are expensive-80 rounds of prc factory ammo for what edge does cost and I've got components to load 300 prc and the edge, dang it build one of each!!

 

[C.O. Shooter]

I love my 338 Lapua. However, if I had to do over again, I may have went 300 Norma mag improved.

 

[FEENIX]

Working on a new build, and need some advice. The rifle will be mainly used at a range from 1000y to one mile, unless I can find a range thats stretches farther, though I may hunt with it as well. I am going with a Impact Precision action. I'm leaning towards Bartlein 1/8 twist 28" for 245g rounds. I'm leaning towards a TT diamond 2 stage. I'm leaning for a chassis and being adjustable, as I'm 6'4", and my daughter who will inherit the rifle is 5'6". Would prefer the rifle be 12lb+ to take a lil of the recoil away for my daughter. Would like to keep the chassis under 2k. I already have a banish 30 gold suppressor, and quick attach muzzle break for it and a set of atlas bipods for it. The scope will be a vortex strike eagle 5-25×56 untill I save up for a vortex razor gen 3 6-36x56. Guess my question is, is there a better build for 1000y-2000y?

The .300 NM/I is probably your easy button. If your action can accommodate ~4" COAL, the 300 RUM, the 30-378 WBY, or Kirby Allen's wildcats (Allen Express and Raptor, if it is in your consideration), you'll need the right bolt face, though.

 

[MagnumManiac]

The only + I can find on 33cals is weight and very little bc gain with comparable bullets. Those heavier drop more. Giving up impact energy over drop for paper isn't worth the extra powder in my book. YMMV? 250gr 30cal is far better than 250gr 33cal bc wise. Depending on which 250gr there's .100 difference. Jumping from 1 mile to 2k can be a lot. I have no confirmed numbers, only computer generated with those. On that same note using 150gr smk 26cal in my setup, it's still supersonic passed 2k.

That is not an apples to apples comparison like you think it is.

A 338 has much heavier and higher BC bullets than 30 cal, drop doesn't matter, it is bucking the wind that counts for ELR.
I have my 300-416 Rigby Improved 40°, it propels 230's well into 3300fps, but for me, this is still limited to 1600 metres (1 mile). The reason is wind drift, nothing else.
A 300 PRC is no 2000yrd gun, if it is, then so is any other SMALL cartridge starting at 6.5mm, which has some of the highest BC bullets out there under 30 cal. It does not make them a 2000yrd cartridge/bullet in my experience, great to a 1000, good to a mile if pushed fast enough.
Supersonic flight is nothing without wind bucking ability…

Cheers.

 

[ARlife4me]

That is not an apples to apples comparison like you think it is.

A 338 has much heavier and higher BC bullets than 30 cal, drop doesn't matter, it is bucking the wind that counts for ELR.
I have my 300-416 Rigby Improved 40°, it propels 230's well into 3300fps, but for me, this is still limited to 1600 metres (1 mile). The reason is wind drift, nothing else.
A 300 PRC is no 2000yrd gun, if it is, then so is any other SMALL cartridge starting at 6.5mm, which has some of the highest BC bullets out there under 30 cal. It does not make them a 2000yrd cartridge/bullet in my experience, great to a 1000, good to a mile if pushed fast enough.
Supersonic flight is nothing without wind bucking ability…

Cheers.

so, a 250gr a-tip (.878 bc) is inferior to a 33cal 250gr at it's best best bc which is .100-.150 less. i can't do a 300gr 30cal. same weight on 250grs bucking wind, so how's that different? either way you compensate for drop and drift. some needs more than others.

 

[ARlife4me]

i didn't state it was best, but it's possible just like 22cals going over 1k.

 

[quandary]

To address your question. I have an MPA chassis and and XLR chassis both are good. The XLR is for hunting the MPA for the range. At the pricing you are looking for I would go with the MPA. I have a BA Hybrid. With the MPA weight kit and Grey Ops side weights the chassis weights 9.4lbs. All in with my action, barrel, optics, suppressor and bipod its about 21lbs. In a 6.5PRC there is virtually no felt recoil. You can do all that for around $1,400. Add $500 if you want to go with the MPA Matrix Pro.

 

[Will.284]

I'm only hunting with whatever my decision will be I live in central Mt where we can shoot a grand easy and we get with like nothing you've ever seen so I want something to buck the wind . A .300 Norma is interesting