Help! DBM and AICS Mag Over-Insertion

[JAYgs8163]

Did you try to

It is an Accurate Mag magazine, but MDT makes an adjustable magazine latch that I'm hoping might be able to be made to fit my bottom metal.

And the last video I with the mag pressed all the way up until it stops and then trying to chamber a round

Did you try adjusting the tab on your Accurate mag? Can you post a picture of your bottom metal installed?

 

[southpa]

Switch to BDL...problem solved
Partly kidding.

 

[Dunderhead]

Did you try to

Did you try adjusting the tab on your Accurate mag? Can you post a picture of your bottom metal installed?

Hmmm I guess I didn't know I could adjust the tab on the mag

Here's some pics. Don't have any of the rear portion.

 

[JAYgs8163]

I'm not 100% positive you can adjust the tab as I have never had the issue you're having. I'm curious what action this stock was inletted for as I look at your above photos and the ejection port for the stock does not even come close to lining up to the ejection port of the action.

 

[JAYgs8163]

Did they send you a CIP bottom metal by mistake and you're using a non CIP mag?

 

[Dunderhead]

I'm not 100% positive you can adjust the tab as I have never had the issue you're having. I'm curious what action this stock was inletted for as I look at your above photos and the ejection port for the stock does not even come close to lining up to the ejection port of the action.

I'm 98% the ejection port is standard 700 length and the Origin is a bit longer. I'm going to machine that back to match once I get everything sorted. And no it's a confirmed 3.715 bottom metal.