Have a new rifle I just built chambered in 30 Nosler. I started with new ADG brass and shot 50 rounds through it to break in and kind of get a start in load development. Most of the brass is coming back at 2.1835" after being shot, and 2 are coming back at 2.1850". Looking at my reamer print out, it's showing a min of 2.1877" and max of 2.1977. So my question is this… would it seem that I should only neck size these since they did not get blown out all the way to the exact chamber dimensions and are still .002" under spec? I did take the 2 biggest pieces and insert into the chamber and the bolt closed just fine.