Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Cerakote, just a few questions????
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Timnterra" data-source="post: 1519447" data-attributes="member: 55944"><p>If you are going to mask off that inside you will have to do a good job of it. Because, the sand blaster will ruin the finish inside the action if you do not intend to coat it. Also make sure you use the Cerakote brand tape or something very good that doesn't leave any residue on the parts when you peel it off because that residue will ruin your finish if it melts on there in the oven. I masked off the inside of a Bordon Rinmrock action and didn't cost the bolt because Bordon tolerances are very tight.</p></blockquote><p></p>
[QUOTE="Timnterra, post: 1519447, member: 55944"] If you are going to mask off that inside you will have to do a good job of it. Because, the sand blaster will ruin the finish inside the action if you do not intend to coat it. Also make sure you use the Cerakote brand tape or something very good that doesn’t leave any residue on the parts when you peel it off because that residue will ruin your finish if it melts on there in the oven. I masked off the inside of a Bordon Rinmrock action and didn’t cost the bolt because Bordon tolerances are very tight. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Cerakote, just a few questions????
Top