Built A Tripod Prototype

Perkules

Well-Known Member
Joined
Dec 11, 2002
Messages
179
Location
Finland
Just the upper part actually. Should I ignore the vertical adjustment? The tripod part is from a telescope,I didn´t mess it up at all so it can still be used.

This is lightweight but I can stand on it... 190 pounds.
rolleyes.gif


All scrap stuff found at my home... will work one day. Ideas,please?

Tripodplan.jpg


Tripod1.jpg


A close look:

Tripodclose.jpg


[ 05-31-2003: Message edited by: Petander ]
 
I can see where the parts for the tripod came from but what parts/stuff did you use to build the dog?

Only difficulty I see is where the butt stock rides the rear rest... think this will cause some vertical shifting?
 
Thanks for the reply,Dave.

Suggestions for the rear rest? Contour it to match the stock? Change the place?

Oh,the dog parts came from other dogs.
grin.gif
 
Petander

I wouldn't change it yet, just be consistent in where you place the stock and how much pressure you apply to the buttstock while shooting.
 
Warning! This thread is more than 22 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top