Bad brass

[Wachsmann]

So I have some "Top Brass" that I pulled out last night and started processing. I got it during when it was about the only thing I could find. After just putting it through the works and seeing the small somewhat hard dings in a lot of it I have to ask myself is it even worth the initial fire forming. I'm really on the fence about this stuff. Cause it may take 2 firings to really get some of the dings out. Some are really close at the shoulder or on the shoulder. It's all 308 win brass. I thought about finishing processing it all and just put it on the shelf for a really rainy day if needed. I kind of think in todays times with powder, primers, and bullets, being not as available and time and cost, when especially trying to make items as consistent as possible for longer ranges my gut is telling its not worth the trouble. You can put your best suit on a turd but it still stinks. What are some of y'all's thoughts? I can get some better brass pretty easy now it seem like Scheels carries a few good brands. I think Hornady would even be much better.

 

[Laelkhunter]

I think if it will chamber, any dents/dings will definitely come out in the first firing. Try it !

 

[Wachsmann]

I was also going to test out some neck mandrels on it and see if I could get some more consistent velocity's out of the stuff. I think I did about 150 cases last night. Annealing, sizing, trimming, deburring, debutring the primer pockets, cleaning the primer pockets, and a corn cob tumble I have a few hours in it now. Maybe I'll load up some of the worse ones and see if it straightens them out. I think the first 50 I did were ok but the next 150 had a mix of some decent dings in them. Probably just need to get me a deburring station instead of doing this all by hand. Hands get to cramping after a while.

 

[M1A1ABRAMS]

So I have some "Top Brass" that I pulled out last night and started processing. I got it during when it was about the only thing I could find. After just putting it through the works and seeing the small somewhat hard dings in a lot of it I have to ask myself is it even worth the initial fire forming. I'm really on the fence about this stuff. Cause it may take 2 firings to really get some of the dings out. Some are really close at the shoulder or on the shoulder. It's all 308 win brass. I thought about finishing processing it all and just put it on the shelf for a really rainy day if needed. I kind of think in todays times with powder, primers, and bullets, being not as available and time and cost, when especially trying to make items as consistent as possible for longer ranges my gut is telling its not worth the trouble. You can put your best suit on a turd but it still stinks. What are some of y'all's thoughts? I can get some better brass pretty easy now it seem like Scheels carries a few good brands. I think Hornady would even be much better.

I bought some Srarline (308 Match) with small primer pockets. I am very pleased with the price & condition. Although I did have a small wait. A even longer wait for 6.5 CM small primer pocket. But I surely won't complain about the quality or pricing. It's nice to have when not available to purchase also.

 

[MagnumManiac]

The dents will disappear with a start load, let alone a 'normal' hunting load.
It don't take much to remove those dents, if a pistol powder at a low charge weight can form an AI chamber without a bullet………