Thanks in advance for any/all assistance.
About 1.5yrs ago I purchased a Rem 700 stock that was taken off a Christensen rifle. Unfortunately I forgot to write the model on the stock. I had life put this build on the back burner but FINALLY getting back to it.
What I am wondering is if someone knows a good way, by measurements from the stock, to figure out which bottom metal it takes? I'm trying this so I don't just start going to buy each type and doing a test fit. I know its a 700 LA, I believe it was for a detachable, but I don't remember.
I can post pics if that will help.
Thanks Again
About 1.5yrs ago I purchased a Rem 700 stock that was taken off a Christensen rifle. Unfortunately I forgot to write the model on the stock. I had life put this build on the back burner but FINALLY getting back to it.
What I am wondering is if someone knows a good way, by measurements from the stock, to figure out which bottom metal it takes? I'm trying this so I don't just start going to buy each type and doing a test fit. I know its a 700 LA, I believe it was for a detachable, but I don't remember.
I can post pics if that will help.
Thanks Again
